Dealing with a Sudden Hot Water System Failure: Key Actions

Dealing with a Sudden Hot Water System Failure: Key Actions

Blog Article

Call Today

We've unearthed this great article on Hot Water Heater Repair listed below on the internet and reckoned it made good sense to relate it with you here.

Many modern homes make use of an electric hot water heater for their furnace, as a result of its comfort as well as simplicity of use. However, just like any other electrical home appliances, problems may emerge with its use, suddenly. It can be really irritating to get up to a cold shower as opposed to a hot one or having your bathroom with water that isn't hot enough and even too hot. Whatever the instance may be, hot water heater issues can be quite aggravating. Luckily, we've made a list of feasible services to your water heater concerns. There are a variety of aspects that might cause much of these issues, it could be a problem with the power supply, the electrical burner, or the thermostat. Before doing anything, ensure you switch off the primary power supply for safety. Whatever the trouble is, getting it repaired should not posture excessive of an issue if you comply with these steps:

Inspect Your Power Supply:

As basic as this might seem, it is really needed. Without sufficient power, your hot water heater will not work. So the first thing to do when your water all of a sudden retires is to verify that it isn't a power problem. Inspect if the fuse is burnt out or the circuit breaker stumbled. If the circuit breaker is the problem, merely turn it on and off once more. Replace any kind of broken or worn-out fuse. Examine the appliance with power after these adjustments to see if it's currently working.

Inspect the Burner in the Water Heater:

If it's not a power issue, after that try taking a look at your burner if it is still working. Test each of your heating elements to ensure the problem isn't with any of them. If any one of them is faulty, replace that component and afterwards check whether the warm water is back on.

Check Your Thermostat:

If your water heater still isn't functioning or the water appearing isn't hot enough, you may require to examine the temperature setups on your upper thermostat. Guarantee the breaker is turned off prior to doing anything. Open the access panel as well as press the red switch for temperature level reset over the thermostat. This need to aid heat the water. Turn the circuit breaker back on as well as inspect if the trouble has actually been dealt with.

Call A Specialist:

If after replacing all defective parts as well as resetting your temperature level, the hot water heater still isn't functioning, you might require to contact an expert plumber for an expert point of view. The trouble with your heating system could be that the cold and hot faucets have actually been switched over or it might be undersized for the quantity of warm water required in your house. Whatever the situation might be, an expert plumber would certainly assist fix the issue.

Final thought

Water heater problems are not always major. A lot of them are due to minor issues like a blown fuse or damaged burner. Changing the malfunctioning parts should do the trick. However, if you are still incapable to address the trouble, give a call to your local plumber ahead to get it taken care of.

Common Reasons Why Your Hot Water Heater Isn’t Working

Water Gets Too Hot

Ouch! You wanted a hot shower, not boiling! If you have a newer model electric water heater, your water heater works with a thermostat (actually, two thermostats). If this thermostat has been jostled — or purposely reset — by someone in your home, the water flow will be much hotter than you expected.

FIX: Adjust the thermostat to a more moderate setting for producing hot water. Forty-nine degrees Celsius is recommended to prevent scalding.

Water Doesn’t Get Hot

This is the opposite of the previous problem, but it’s almost as bad. Your flow of hot water is merely lukewarm or even incoming cold water. Once again, an incorrect thermostat setting, or a faulty thermocouple in a gas water heater, could be to blame. Another explanation might be that there’s no power to the water heater (in the case of an electric heater) or the pilot light has gone out (if you have a gas unit).

FIX: Adjust your thermostat as necessary. If that doesn’t do the trick, check the power supply. Another possibility is the replacement of a damaged thermocouple in gas water heaters.

Leaking Water Heater

A leaking water heater (a sign may be low hot water pressure, or not enough hot water to shower) might be a reason to push the panic button… but first, take a few minutes to check where the leakage is coming from. Leaks near the top of the heater tend to indicate a problem with a valve, which won’t need a major repair. However, a leak from the water heater base is more serious.

FIX: You may need a qualified plumber to replace your drain valve or TPR (temperature pressure relief) valve. When your water heater is leaking from below, your plumber might be able to fix it if you call them soon enough. Otherwise, you will need to have a new water heater installed.

Noisy Water Heater

Sometimes your water heater might make some peculiar noises, loud enough to compete with your singing in the shower. Are these a cause for alarm? It depends on exactly what kind of sounds you are hearing. Sizzles and rumbles are both red flags, indicating a heavy sediment buildup in your hot water tank that might cause a breakdown in the near future. In addition, banging is a sign of a water hammer, which can lead to serious damage to your pipes.

FIX: To stop sizzling or rumbling, turn off the tank and have it flushed by a reliable plumbing company ASAP. Ask your plumber to install a water hammer arrestor to quiet down the banging and save the pipes.

Pilot Light Keeps Going Out

Many pilot lights go out once in a while, but when your water heater pilot light keeps going out continually, it’s a problem. And the chances are good that that problem stems from either a shortage of combustible air or a malfunctioning thermocouple.

FIX: Increase the air supply around your water heater by cleaning dust and lint off the appliance and clearing any clutter from the area around it. A bad thermocouple will require expert plumbing repair and is more than basic gas water heater troubleshooting.

Water Smells Bad

The water from your residential plumbing pipes should smell neutral. If it has a strong unpleasant odour, something’s wrong. To check whether your water heater is at fault, turn on a hot water faucet and let it run for a few minutes. And, yes, use your nose to determine exactly what you are smelling.

FIX: For a garlicky odour, relight the pilot light on your water tank. When you detect the scent of garbage, you’ll need a professional plumber to flush the hot water tank and possibly replace the anode rod. A strong smell of rotten eggs could signal a hazardous gas leak; turn off the gas supply if possible, get everyone out of your house, and make an emergency call to the gas company.

Water Looks Brown Or Rusted

The first thing to do is ask yourself, “Is the brown, rusty-looking water coming only from my hot water taps?” If the answer is yes, then most likely, either the anode rod or the water heater interior is starting to rust, especially if your hot water heater is nearing the end of its life expectancy. (A “no” answer means the issue does not originate from the hot water heater but rather from the water supply.)

FIX: Contact a plumber to inspect the water heater. If you catch the problem quickly enough, it might be fixable. Otherwise, you’ll need a water heater replacement. Consider installation of an efficient new tankless water heater.

https://www.huskyair.com/blog/hot-water-heater-isnt-working/

I stumbled upon that blog posting about How to Troubleshoot and Repair an Electric Water Heater when doing a search on the web. Don't hesitate to take the opportunity to promote this post if you appreciated it. Thank you for going through it.

Additional Resources

Report this page